Stage 7
Interior Procedure
Wet Stall
Time Frame: 20 - 30 Minutes
Detail Depot Detailing Systems Printable Detailers Manual:
Supplies & Equipment Needed: Detail Product Needed:
* Hot Water Extractor DV 12 - DV 5
* Wet - Dry Vacuum
* Compressed Air
* Detail Brush
* Interior Brush
* Interior Towels
* Detail Gloves
Interior Extracting:
* Make sure your extractor is hot - clear extractor line of cold water - for line water is hot.
Clear the cooler water by spraying back into your heat tank.
* Remove all floor mats and lose articles from the interior and open all
compartments - quickly appraise your objective.
* Now perform a quick Wet/Dry vacuum to remove excess dirt and debris from the interior.
* Remember - between the seats - under the seats - seat cracks - console crevices
this is a pre vacuum - you will be performing your extracting process and final
vacuum so keep moving - this is a preliminary step.
* Pre spray water based spots on carpets and seats with Orangeen.
* Pre spray oil based spots on carpets and seats with Solv All.
* Pay special attention to the drivers side compartment due to the fact it
has the most abuse & use - the potential buyer will check this area out first
and first impressions can make the difference - this can literally make or
break the purchase right off.
* Pay attention to stained areas - these may need additional cleaning.
* Start on the drivers front carpet - let the extractor do its thing - remember to
get every square inch - do not forget the drivers pedals - small stones or rocks
stuck into the crevices of pedals? - remove with a small flat head screw driver
road tar on pedals - remove with Solv All - make sure the seat is moved all
the way back - and make sure it is all the way forward when cleaning the rear.
* The more you dry extract the faster your materials will dry.
* Proceed to drivers front seat - many angels so take your time and catch them all
make sure the drivers seat is all the way forward - you need to get under the seats.
* Drivers door panel extract.
* Drivers side rear carpet - drivers side back seat - drivers side rear door panel.
* Remove extractor hoses from the vehicle and proceed to the passengers side
of the vehicle - this is also why it so important to keep your extractor and vacuum hoses clean.
* Extract passengers front carpet - passengers front seat - passengers front
door panel make sure the passengers seat is moved all the way back.
* Proceed to the passengers rear carpet - passengers rear seat - passengers rear door panel.
* Re-check bad stains that may have wicked up and re-do if needed at this time.
* Proceed to the trunk compartment and extract / pay attention to stained side
walls of the trunk compartment as well.
* You are almost done extracting: If you have decided to extract the
floor mats do so now - if placing a interior fan into the interior - do so now.
* When extracting floor mats - place on a clean area and extract -
mat hooks work great here.
* Extracting completed - shut down your extractor - empty out refuge tank - place
extractor and lines back into their perspective place in your shop.
Printable Detailers Manual Edition: Property Of Detail Depot Detailing Systems
Interior Procedure
Wet Stall
Time Frame: 20 - 30 Minutes
Detail Depot Detailing Systems Printable Detailers Manual:
Supplies & Equipment Needed: Detail Product Needed:
* Hot Water Extractor DV 12 - DV 5
* Wet - Dry Vacuum
* Compressed Air
* Detail Brush
* Interior Brush
* Interior Towels
* Detail Gloves
Interior Extracting:
* Make sure your extractor is hot - clear extractor line of cold water - for line water is hot.
Clear the cooler water by spraying back into your heat tank.
* Remove all floor mats and lose articles from the interior and open all
compartments - quickly appraise your objective.
* Now perform a quick Wet/Dry vacuum to remove excess dirt and debris from the interior.
* Remember - between the seats - under the seats - seat cracks - console crevices
this is a pre vacuum - you will be performing your extracting process and final
vacuum so keep moving - this is a preliminary step.
* Pre spray water based spots on carpets and seats with Orangeen.
* Pre spray oil based spots on carpets and seats with Solv All.
* Pay special attention to the drivers side compartment due to the fact it
has the most abuse & use - the potential buyer will check this area out first
and first impressions can make the difference - this can literally make or
break the purchase right off.
* Pay attention to stained areas - these may need additional cleaning.
* Start on the drivers front carpet - let the extractor do its thing - remember to
get every square inch - do not forget the drivers pedals - small stones or rocks
stuck into the crevices of pedals? - remove with a small flat head screw driver
road tar on pedals - remove with Solv All - make sure the seat is moved all
the way back - and make sure it is all the way forward when cleaning the rear.
* The more you dry extract the faster your materials will dry.
* Proceed to drivers front seat - many angels so take your time and catch them all
make sure the drivers seat is all the way forward - you need to get under the seats.
* Drivers door panel extract.
* Drivers side rear carpet - drivers side back seat - drivers side rear door panel.
* Remove extractor hoses from the vehicle and proceed to the passengers side
of the vehicle - this is also why it so important to keep your extractor and vacuum hoses clean.
* Extract passengers front carpet - passengers front seat - passengers front
door panel make sure the passengers seat is moved all the way back.
* Proceed to the passengers rear carpet - passengers rear seat - passengers rear door panel.
* Re-check bad stains that may have wicked up and re-do if needed at this time.
* Proceed to the trunk compartment and extract / pay attention to stained side
walls of the trunk compartment as well.
* You are almost done extracting: If you have decided to extract the
floor mats do so now - if placing a interior fan into the interior - do so now.
* When extracting floor mats - place on a clean area and extract -
mat hooks work great here.
* Extracting completed - shut down your extractor - empty out refuge tank - place
extractor and lines back into their perspective place in your shop.
Printable Detailers Manual Edition: Property Of Detail Depot Detailing Systems
* Oramgeen
* Pro Tex All
* Instant Shine
* Aerosol Glass - Pure Glass
* Solv All
* Pro Tex All
* Instant Shine
* Aerosol Glass - Pure Glass
* Solv All
